I might recommend fileflows over tdarr- but either way some kind of similar solution is almost mandatory with the grab bag of arbitrary encodings you find out there.
I might recommend fileflows over tdarr- but either way some kind of similar solution is almost mandatory with the grab bag of arbitrary encodings you find out there.
hunter2
A gallon glass carboy is $20-25 and that’s going to be your biggest up front expense. That’s reusable, however so once you’ve got that you’re not going to need another for simple small batches. Champagne yeast is like $10-20 for 10-20 packs (figure a dollar per pack) and each pack can easily make 2 gallons if you’re smart enough to split it in half. 3lbs of raw honey from Costco will run $12-15 and a gallon of boiled water rounds out your list. Yeast nutrient is probably a good idea since it almost guarantees good results (1lb is like $10-15 and you only use 1/4 tsp or so per gallon batch). One-way air locks for brewing with stoppers are $2-10 depending on how many you buy (also reusable). So your first batch is your most expensive at $85 absolute worst case with today’s prices. From there on out subsequent batches cost only the honey, water, and any fruit or spices you want to try adding. As far as hobbies go, that’s not bad considering how much variety there is in it. I can’t comment on beer, but mead is dead simple as long as you keep everything sanitized before and after brewing.
As someone who makes meads/wines in a closet and has done so while renting, I don’t particularly see the relevance as long as your batches are small and contained… Typically, the tools and ingredients aren’t wildly expensive either if you’re keeping things simple (in the US, anyways). Honestly, I don’t see how more demographics don’t get into the basics of homebrewing. It’s dead simple to make something “passable” and with time and effort you can even make something good/great!
The Truecharts version of Qbittorrent has gluetun baked in as an option already. Initial configuration can be a bit of a pain depending on your VPN provider, but it seems to work beautifully once set up.
Why would I recommend Fileflows? It was a little more user friendly in my experience without requiring pulling in configurations from other sources. I know there are repos chalk full of Tdarr settings and configs, but for simple setups and DIY I preferred the Fileflows interface. The end result is basically the same, so pick your poison.