Hey all, lurker for a bit, but just joined because I’ve started my journey of self hosting the simple stuff (or at least I hope it’s simple). For the past couple years I’ve been using a RPi Zero W for PiHole, and more recently go into Jellyfin and Home Assistant, using an RPi4 and an RPi3+ respectively. I’ve also got a hand-me-down Synology ds214j NAS with 2x8TB in RAID0 RAID1, which is about half full atm. I’m not expecting to expand that storage anytime soon, so I’ve pivoted to an attempt at combining the 3 Pis above into one NUC/SFF/etc device with a roughly similar power draw. Also looking at re-jumping back into 3D printing using OctoPrint.
I’ve looked briefly at jumping to a Pi5, but that led me down the rabbit hole with Jeff Geerling’s article/video on Pi vs. NUC. I’ve continued to putter around looking at NUCs in the ~$200 range. Hoping to stick with MinisForum, GMKTek, or Beelink if possible, but only because… it’s all I know. I’d like to also tinker deeper with Linux flavors, as I’m a noob at best with it but want to at least have some growing knowledge, as I’ve primarily been a Windows gamer and use Apple at the office almost exclusively. I’d like to try staying with AMD as I’ve slowly moved over from the “dark side” (don’t hurt me) that is Intel and Nvidia.
Last nugget is that I’ve never tinkered with Docker, as it seems that may be the best route to host all these apps on one contiguous installation. I’ve new-ish to VMs too, so anything “Baby’s First VM” would be nice.
I know I made a giant pile of wants/needs, so if there’s no magical unicorn, I’m cool with other ideas. Thanks in advance, and I’m really keen on seeing what options I have.
Pi 4 should be plenty to run Jellyfin, homeassistant, pihole and octoprint. Docker setup is pretty straightforward, and I can vouch that HA & pihole containers work great on RPi, if you want to leave the Jellyfin setup as-is and put the others alongside.
If you’re looking for an excuse to expand, my vote is for an N100 type system. I got one with 4 ethernet ports, PCIe for a wifi card, couple of NVME slots, and a half dozen SATA ports for $100-150. That’s a huge step up in potential without much increase in power draw. With the right wifi card, you can even use it to replace your WAP/router.
Maybe I will try to redo the Pi4. Just wanna see if I can make a full backup of Jellyfin’s config beforehand. Or, y’know, just buy a few extra microSD cards.
But yes, the excuse is valid. I feel like eventually I’ll hit a wall with the Pi4, but I also dunno how much more I’m trying to expand anyway. Basically trying to get to that low power, self-sufficient plateau without going too overboard.