https://halestrom.net/darksleep/blog/054_nvme/

Summary: two Silicon Power P34A80’s died within a few months of use, the second one was the warranty replacement of the first. In both cases sectors suddenly became permanently unreadable.

SFF = Small Form Factor. It’s smaller than traditional ATX computers but can still take the same RAM, processors and disks. Motherboards and power supplies tend to be nonstandard however. Idle power consumptions are usually very good.

USFF = Ultra Small Form Factor. Typically a laptop chipset + CPU in a small box with an external power supply. Somewhat comparable with SBCs like Raspberry Pis. Very good idle power consumption, but less powerful than SFF (and/or louder due to smaller cooler) and often don’t have space for standard disks.

SBC = Single Board Computer.

I wouldn’t attack via USB, that path has already been too well thought out. I’d go for an interface with some sort of way to get DMA, such as:

• PCIE slots including M.2 and external thunderbolt. Some systems might support hotplug and there will surely be some autoloading device drivers that can be abused for DMA (such as a PCIE firewire card?)
• Laptop docking connectors (I can’t find a public pinout for the one on my Thinkpad, but I assume it’ll have something vulnerable/trusted like PCIE)
• Firewire (if you’re lucky, way too old to be found now)
• If you have enough funding: possibly even ones no-one has thought about like displayport + GPU + driver stack. I believe there have been some ethernet interface vulnerabilities previously (or were those just crash/DOS bugs?)

I recommend using a different set of flags so you can avoid the buffering problem @[email protected] mentions.

This next example prevents all of your ram getting uselessly filled up during the wipe (which causes other programs to run slower whenever they need more mem, I notice my web browser lags as a result), allows the progress to actually be accurate (disk write speed instead of RAM write speed) and prevents the horrible hang at the end.

dd if=/dev/urandom of=/dev/somedisk status=progress oflag=sync bs=128M

“oflag” means output flag (to do with of=/dev/somedisk). “sync” means sync after every block. I’ve chosen 128M blocks as an arbitrary number, below a certain amount it gets slower (and potentially causes more write cycles on the individual flash cells) but 128MB should be massively more than that and perfectly safe. Bigger numbers will hog more ram to no advantage (and may return the problems we’re trying to avoid).

If it’s an SSD then I issue TRIM commands after this (“blkdiscard” command), this makes the drive look like zeroes without actually having to write the whole drive again with another dd command.

N.B. to anyone reading this: ask your isp to “opt out of CG-NAT”. Talking about IPv6 may confuse the staffer you’re talking to, it’s partially related but not the fully picture.

Especially handy when your university has contracts with Microsoft so you aren’t supposed to use competitive software

What…

Well it’s a good thing that Microsoft has embedded linux + its userspace in windows via WSL 2. That means using Linux + its userspace in Alpine is completely Koscher as long as you rename the root Alpine project to be “OceaneAlpine”, right?