I have a HDD 4tb Toshiba drive I had in a Raid 1 NAS device (NSA320) that failed in the raid and I replaced it and rebuilt the raid and life was good.

I have finally moved to a better custom TrueNas scale setup with 2x 8tb HDD in a Raid 1 with weekly encrypted backups to online cloud. I have 2 4tb Toshiba HDDs that match closely with the dead hdd.

I want to try to recover data from it mainly because I want the experience… Let me explain. The drive clicks, yes you can hear the disks spin up to speed and then you hear clicking as it’s trying to read.

I want to know if I can start off trying to swap the circuit board to rule that out without much issue? I have true HEPA filter air purifiers and I can rotate and angle them to have a positive pure air pressure if I need to open it up and swap out the arms.

Is it worth trying? Anything I should know or think about in my decision to try this?

  • Mountain_Mike_420@lemmy.mlEnglish
    0·
    5 months ago

    Do it! Yeah start with the mother board and see what happens and then open the fucker up and replace the try to move the platters to working drive. You don’t have anything to lose so why not. For a quick and dirty clean room run the shower really hot for a few minutes to make a bunch of steam and then wait for the humidity to naturally equalize, boom you got a few minutes to do your swap job.

    • dmention7@lemm.eeEnglish
      1·
      5 months ago

      For a quick and dirty clean room run the shower really hot for a few minutes to make a bunch of steam and then wait for the humidity to naturally equalize, boom you got a few minutes to do your swap job.

      I’ve never heard of this… what’s the idea behind it? That you get the RH near 100%, and any dust particles will be a nucleation point for water to condense on, causing them to literally rain out of the air?