Hi everyone,
I’m not sure if this is the right community, but the home networking magazines seem to be pretty dead. I’m a bit green with regard to networking, and am looking for help to see if the plan I’ve come up with will work.
The main image in the post is my current network setup. Basically the ISP modem/router is just a pass through and the 10 Gb port is connected to my Asus router, which has the DHCP server activated. All of my devices, home lab and smart home devices are connected to the Asus router via either Wifi or Ethernet. This works well, but I have many neighbours close by, and with my 30+ wifi devices, I think things aren’t working as well as they could be. I guess you could say one of my main motivations to start messing with this is to clean it up and move all possible devices to Ethernet.
The planned new setup is as follows, but I’m not sure if it’s even possible to function this way.
https://i.postimg.cc/7YftSFt6/IMG-9281.jpg
ISP modem/router > 2.5 Gb unmanaged switch > 2.5 Gb capable devices (NAS, hypervisor, PCs) will connect directly here, along with a 1 Gb managed switch to handle the DHCP > Asus router would connect to the managed switch to provide wifi, and remaining wired devices will all connect to the managed switch as well.
Any assistance would be appreciated! Thanks!
Edit: fixed second image url
You must log in or register to comment.
The main issue is your 30+ Wi-Fi devices. One AP can only handle this much total bandwidth. But first, it looks like you waste 2gb of your fibre speed? Get a compatible router.
For your setup it almost looks like you’re better off with a total 10gb internal speed. And get 2 more AP, one dedicated for your smart home, one for „less important devices“ and use the ASUS for the rest. - remember to use different channels on each AP.
So in short hook your HV,NAS,PC,[new router w/ AP?],[AP2],[AP3],[AP1?] on a new 10GB switch. Split your devices over the 3 AP, on different channels
Edit: or you could get one of those for cheaper „Qnap QSW-M2108R-2C“ That is a 2.5G with two additional 10G ports so you could plug your new router into one of them and use the other for later use of the NAS if it supports that speed
OP needs a proper router that make use of their 3g fiber which will be mostly newer and powerfull and has better wifi. That should be their 1st priority.
Edit: You don’t need a 2.5gb ethernet (or better for futur proofing) for every client, but that NAS and Hypervisor could use that bandwith so consider yor options while you are at it.
Acronyms, initialisms, abbreviations, contractions, and other phrases which expand to something larger, that I’ve seen in this thread:
Fewer Letters More Letters AP WiFi Access Point IP Internet Protocol IoT Internet of Things for device controllers NAS Network-Attached Storage NAT Network Address Translation PIA Private Internet Access brand of VPN VPN Virtual Private Network
7 acronyms in this thread; the most compressed thread commented on today has 8 acronyms.
[Thread #202 for this sub, first seen 9th Oct 2023, 02:25] [FAQ] [Full list] [Contact] [Source code]
